SINGUMATORS

Singumator (ritual lift) - is a device designed for mechanical lowering of the coffin. Singumator carries out the ritual of burial procedures skillfully and correctly. Lift allows you to lower the coffin to the grave slowly and carefully. Singumator in great demand in the cramped conditions of limited space in the cemetery, provides convenience and accuracy performance of the ritual.
Combine "Requiem" produces and supplies singumators on orders of ritual services and administration of cemeteries.
Singumator (ritual lift) comes in the following set:
Pole - 2 pcs.
Rod - 2 pcs.
Belt - 2 pcs.
Cover the top - 4 pcs.
Cover the bottom - 4 pcs.
Passport and manual -1 pc.

Specifications of singumator:
The maximum length of lowering - 2 m
Maximum load weight - 250 kg
The maximum length of the coffin - 2200 mm
Gear ratio gearbox - 1:27
The distance between the belts - 1100 mm
Dimensions - 2450 x 1250 x 300 mm
Weight of ritual lift - no more than 70 kg

Drawing of general form of singumator

Structure description of singumator
Ritual lift consists of poles 1; working hollow rods 2, which are connected with poles; belts 3, which are wound on the rods; the flywheel 4, stretched over a pole of upper lids (metal) 5; lower lids (plastic) 6

Ritual lift assembly (scheme)

The assembly sequence of ritual lift
The assemblage of singumator perform on a flat surface in the following order:
1. Set a pole in parallel to each other at a distance of 2,5 m.
2. Rotate shafts of poles so that the buttons are located on-latches were in the top position. Shafts on leading pole of singumator (pole with a flywheel) rotated by rotating the flywheel 4.
On the remote pole shafts easily rotated by hand.
3. At the same time to combine both rods with the shafts of one of the poles, as shown in Scheme pipe joints with singumator's pole. Similarly, to connect rods with shafts of other pole. Spring-loaded buttons fix the position of the hollow rods on the singumator's shafts.

Scheme of connection of the pipe with singumator's pole - in preparation

4. Attach straps to singumator's rods using staples so that staples were in the top position and the belt was located over rods.5. The rotation of the flywheel counterclockwise wind the straps evenly on both rods.

To avoid the break of winding mechanism of ritual lift belt tension is barred during a load on them!
6. Raise the ritual lift behind the poles and place it over the pit.
The order of the ritual lift
1. Set ritual lift in a horizontal position on a flat surface, so that the edge of the pit were in equidistantly from  poles.
2. Ensure the belt tension on the rods.
3. Set the weight on the belts.

4. Lower load on the belts down by rotation of the handwheel clockwise.
Recommended time of lowering of the coffin - 3 ... 5 minutes
The recommended frequency of rotation - 60 ... 120 rpm.
Singumator - mechanism just for lowering!
To avoid breakage of winding mechanism is strictly forbidden to raise the load on the belts!

5. After lowering to the bottom of the hole rotate the flywheel of singumator clockwise until full release straps.
6. Detach the bracket belts and remove from the pit.
To avoid getting stuck belt straps under the weight it is recommended to unfasten clamps before removing the belt!
7. Take ritual lift from the burial place on a flat area.

 Singumator with manual transmission

Singumator with electric transmission